lutron motion sensor light switch manual

Motion Sensitivity Adjustment Instructions.

Low sensitivity can be used in rooms where a hallway is connected and where there may be the chance of an accidental turn on indirectly with a occupant passing by. High sensitivity is typically used to ensure that the lights turn on with all motion sensed and is typically used in dark rooms and in rooms where the switch may not be readily accessible. There are only two settings with Low Sensitivity being the other level. The default setting on the sensor switch is High Sensitivity. This feature is used to adjust the level of sensitivity your sensor will have to detect motion.

You will need to remove the wallplate around the unit to access the Auxiliary Button needed for this step.

Then would only turn back on after vacancy was achieved after the timeout period selected. However, with a manually press of the switch button to turn lights off, the switch would stay off as long as occupancy was sensed. This setting turns the lights on with occupancy and off with vacancy according to the timeout selected. If button pressed to turn off lights manually in this mode, the lights will continue to stay off until vacancy is sensed and will turn on the next time occupancy was seen.Īuto-On and Auto-Off (Occupancy mode) Off-while-occupied ENABLED. This usually takes a few weeks with several button pushes within the 5 second range to learn. The sensor will learn your preferred light level over time.

If the switch turns on when there is enough natural light, or if the switch does not turn on when there is not enough natural light, press the On/Off button within 5 seconds of entering the room. This Mode will train the lights to turn on only if natural light in the room is low. Manual-On and Auto-Off (Vacancy mode) This setting allows the user to disable the Occupancy function and just use the sensor switch for Vacancy which requires you to manually turn the lights on and the switch will then turn them off after the selected timeout with vacancy.Īuto-On daylight sensing and Auto-Off Off-while-occupied ENABLED. If lights are manually turned off using the main button on switch, they will turn back on within 25 seconds if occupancy is sensed. Lights will turn on when room is occupied and turn off after time out setting when vacated. This is the default setting and mode that most sensors are set to. *The following Sensor Mode features are only available for Occupancy model numbers and NOT on Vacancy models.Īuto-On and Auto-Off (Occupancy mode). Programming is made simple by just press and holding the tap button and counting the number of flashes. The longer options allow you to have the lights on as you know you will be re-entering the room shortly upon leaving.

The lower timeout options are great for rooms and spaces where a light is needed for a quick task and then is no longer needed after words. The options for these timeout selections are 1,5,15 and 30 minutes. The Timeout feature for the Maestro Sensors is a programmable setting that determines how long the lights will remain on after the room has been vacated, and motion has not been detected. Below is a brief description of each programming option. The Maestro Sensor has many programming options. Auto-On and Auto-Off (Occupancy mode) Off-while-occupied DISABLED. 5 Minutes (15 minutes for MS-OPS6M2-DV & MS-VPS6M2-DV models) Maestro Sensors Advanced Programming Features Explained

Lutron motion sensor light switch manual